GA-6024 Pull Type Adhesion Tester
- وصف
- سؤال
وصف
Pull Type Adhesion Tester
1.Test Standard
The pull-type adhesion meter conforms to the standard requirements of GB/T 5210, ايزو 4624 and ASTM D 4541.
2.صroduct دescription
The adhesion of the coating with the substrate can be quantified by the use of the open method, which means that the external force of the coating from the substrate to a specific area is required to be expressed by Mpa.
Its measuring principle is as follows: first round forging die by glue and adhesive coating on the surface under test, after a period of maintenance, through measuring instrument installed inside a spring places a lift to the circular forging die.When the circular forging die is pulled off the surface of the coating, the indicator on the scale shows the value of the adhesion of the coating to the substrate.
The instrument is operated by hand and is mainly used for construction site determination, especially in engineering acceptance.The application range includes the detection of deck coatings or spraying, stainless steel, aluminum products or coatings on concrete.
Pull Type Adhesion Tester
3.المؤشرات الفنية الاساسية
| مادة | Anodized aluminum fuselage, steel base |
| Standard configuration | Pull-type adhesion tester, die (20), Araldite 1 صندوق, pedestal support ring, magnetic forging die clip, forging die cutter, ratchet wrench (limited to range 3&4), suitcase and operation manual |
4.Order Information
NO-1 Measure Range：0-3.5الآلام والكروب الذهنية
NO-2 Measure Range：0-7.0الآلام والكروب الذهنية
NO-3 Measure Range：0-15الآلام والكروب الذهنية
NO-4 Measure Range：0-22الآلام والكروب الذهنية
NO-5 Measure Range：0-0.2الآلام والكروب الذهنية
NO-6 Meausre Range：0-3.5Mpa （The concrete is specially coated with the forging die with a diameter of 50mm）
