Тестер адгезии притяжного типа GA-6024
- Описание
- Расследование
Описание
Pull Type Adhesion Tester
1.Test Standard
The pull-type adhesion meter conforms to the standard requirements of GB/T 5210, ИСО 4624 и АСТМ Д 4541.
2.пудивление Дescription
The adhesion of the coating with the substrate can be quantified by the use of the open method, which means that the external force of the coating from the substrate to a specific area is required to be expressed by Mpa.
Its measuring principle is as follows: first round forging die by glue and adhesive coating on the surface under test, after a period of maintenance, through measuring instrument installed inside a spring places a lift to the circular forging die.When the circular forging die is pulled off the surface of the coating, the indicator on the scale shows the value of the adhesion of the coating to the substrate.
The instrument is operated by hand and is mainly used for construction site determination, especially in engineering acceptance.The application range includes the detection of deck coatings or spraying, нержавеющая сталь, aluminum products or coatings on concrete.
Pull Type Adhesion Tester
3.Основные технические параметры
| Материал | Anodized aluminum fuselage, steel base |
| Стандартная конфигурация | Pull-type adhesion tester, die (20), Araldite 1 коробка, pedestal support ring, magnetic forging die clip, forging die cutter, ratchet wrench (limited to range 3&4), suitcase and operation manual |
4.Order Information
NO-1 Measure Range：0-3.5МПа
NO-2 Measure Range：0-7.0МПа
NO-3 Measure Range：0-15МПа
NO-4 Measure Range：0-22МПа
NO-5 Measure Range：0-0.2МПа
NO-6 Meausre Range：0-3.5Mpa （The concrete is specially coated with the forging die with a diameter of 50mm）
