GA-3010 Desktop Universal Testing Machine

Description

Desktop Universal Testing Machine

Main function:

This machine is suitable for rubber, plastic, tires, rubber hose, adhesive tape, sole, thin films, the force that press a gram, FRP, ABS, EVA, PU, aluminum composite pipe, composite materials, waterproof materials, fiber, textile, wire and cable, paper, gold foil, belt, silk thread, spring, timber, medicine, packaging materials, adhesive tape and so on carries on the tensile, compression, tear, peel (either 90 degrees and 180 degrees) and other mechanical properties test and analysis.

This machine is combination of electronic technology and mechanical drive new material testing machine, the measurement and control of load, deformation and displacement is of high accuracy and sensitivity, this series of machine adopts single space structure, test space in space, mainly is suitable for the test load is lower than 5 kn metal, non-metallic materials testing, has the stress, strain and displacement control method can find out the most energetically, tensile strength, bending strength, compression strength, elastic modulus, breaking elongation, yield strength and other parameters.

Desktop Universal Testing Machine

Introduction to control software

Software operating system language: Simplified Chinese/English.

Unit of force: N, KN, Kgf, Lbf, unit of length: mm, cm, in can be converted freely

Automatic zero: the measuring system will automatically zero after the computer receives the instruction to start the test.

Display mode: data and curve are displayed dynamically with the test process;

Results reproduction: the test results can be accessed at will, and the data curve can be reanalyzed;

Comparison of results: Multiple test characteristic curves can be superposition, reappear, enlarge and present a group of samples in different colors.

Emergency stop: the emergency stop switch is used to cut off the power supply of the whole machine in emergency;

Desktop Universal Testing Machine

Control mode:

Computer software to set the speed, set the load fracture (rupture), running time and other control methods

Automatic determination of material fracture, collapse, etc., and automatic stop, can set automatic return

Desktop Universal Testing Machine

Type of curve:

Load – displacement, load – time, displacement – time.

Stress-strain, strain-time, stress-time.

The horizontal and vertical coordinates of the curve can be set arbitrarily.

Test data available:

Maximum strength, minimum strength, fracture, upper and lower yield strength, tensile strength, compressive strength, elastic modulus, elongation, peel interval maximum, minimum, average, etc.With overload, overcurrent, overvoltage, undervoltage, overspeed, stroke and other multiple protection.

The results are derived from the crystal report format currently used by the national standard.

Technical parameters:

Capacity selection: 500kg sensor, HIGH precision American load cell

Accuracy level: 0.5

Effective measuring force range: 0.4% ~ 100%

Force measurement accuracy: within ± 0.5% of the indicated value

Resolution of testing machine: the maximum load is 1/±250000 yards, the inside and outside are not classified, and the whole resolution is unchanged

Load transducer

Basic configuration: Tension and pressure sensors (maximum load)

Effective test width: 400mm

Effective drawing space: 600mm (without fixtures)

Test speed range: 0.01 ~ 500mm/min

Displacement measurement accuracy: within ± 0.5% of the indicated value

Test bench safety device: electronic limit protection

Test bench return function: manual or automatic two choices, after the end of the test automatically or manually return to the initial test position

Overload protection: when the maximum load exceeds 10%, the machine will be protected automatically

Fixture configuration: one set of standard three-point bending fixture

Host size: 700×550×1350mm

Motor: 220V±10% 0.4KW Taiwan Dongyuan servo motor

Transmission mechanism: high precision ball screw

Main engine weight :(about) 200 Kg