GA-1001-B TOCED SCREE SCHECH FLUST INDICE TESTER

Descrizione

GA-1001-B TOCED SCREE SCHECH FLUST INDICE TESTER

Standard:

GB/T3682-2000 《Determination of melt flow rate and melt volume flow rate of thermoplastics》

ISO 1133：1997《Determination of melt flow rate and melt volume flow rate of thermoplastics》

ASTM D1238 《Standard Test Method for Determination of flow rate of Thermoplastic Melt by extruded plasticizer》

GA-1001-B TOCED SCREE SCHECH FLUST INDICE TESTER

Description:

Used for testing all kinds of plastic, resin in the state of viscous flow through a certain temperature and load, every 10 min module and melt flow rate through the standard port MFR value, it is suitable for high temperature of polycarbonate, aromatic sulfone, fluorine plastic, nylon and other engineering plastics, can also be applied to polyethylene (PE), polystyrene (Ps), polipropilene (PP), ABS resin, polyformaldehyde (POM), polycarbonate (PC) resin with lower melting temperature, such as plastic test, widely used in plastic production, plastic products, such as petroleum and chemical industry and related colleges and universities, scientific research units, and the commodity inspection department.

Test Methods:MFR+MVR Methods

Modalità di visualizzazione: 7-inch touch screen controller

Product Character:

1.English LCD Touched Screen.Ø

2.Hand and Automatic cutting material.

3.Double temperature control system, temperature control precision is more accurate, higher heating efficienc

4.Double imported sensors, more accurate temperature gradient from top to bottom, can be used independently, and improve the service life.

5.Cylinder for imports hartz alloying nitriding treatment, opening mould for carbon tungsten steel material, material reality.

6.Insulation barrels of sus304 stainless steel material for the whole, long-term high temperature does not rust.

7.Automatic calculation results, and print.

8.Have USB connector,can connect computer.

GA-1001-B TOCED SCREE SCHECH FLUST INDICE TESTER

Specifica

Modello	GA-1001-B
Loading Barrel parameters	Inner hole Φ9.550±0.025mm
Cylinder diameter	Φ2.095±0.005mm
Outlet length	8.000±0.025mm
Intervallo di temperatura	Room Temperature~450℃
Fluttuazione della temperatura	±0.2 ℃
Temperature uniformity	±1℃
Risoluzione della visualizzazione della temperatura	0.1℃
Display resolution	0.1℃
Time display resolution	0.1S
Displacement accuracy	0.001mm
Volume timing accuracy	0.001S
Testing scope of mass method	0.1-150g/10min
Range of test results by volumetric method	50-5000cm³/10min
Weight parameters are as follows:
Weight accuracy	±0,5%
Basic configuration	A 0.325kg
	B 1.2kg
	C 2.16kg
	D 3.8kg
	E 5kg
	F 10kg
	G 12.5kg
	H 21.6kg
Position detection
Loop distance from up and down	30mm
Control precision	± 0.1mm
Test flow control
Times of cutting the material	0~10 times
Material cutting interval	0~999s(set reference Table 2)
Control flow reaches the set temperature without volatility
Barrel temperature time	15 min.
Material be installed	1 min.
Material sample temperature recovery time	4 min.
When binder set	1min
Output mode	Micro-automatic print output
Cut material methods	Hand and Automatic Cut
Test load	Eight sets of weights
Energia	AC220V±10% 50/60HZ